Intermediate Face: The Nose Part II

Part 2 of 5: The Nose

This video explains how I use gouges, knives, and chisels to shape parts of the schnoz. Feel free to scrub through to find the parts you need help with. P.S. There are paint smudges on my hand, so excuse that.

This is an Intermediate level project, carving the face in Plains Cottonwood Bark.

This project series spends a substantial amount of time breaking down the setup of the face. It is very important to understand how the major shapes (eyes, nose, mouth, etc) interact with one another. Many carvers make the mistake of adding detail to the face before they have properly set up the features. This series helps carvers avoid that pitfall by showing a basic understanding of the proportions of the male human face. Details of the face are also covered in this series, along with some of the tools and tricks developed to achieve realistic wrinkled skin.

Tools Used:

If you do not have the same tools, remember you do not have to have the exact same sizes-- just within the same size range. For example a #4 25mm can be replaced with a #2 or #3 in a similar width. #4 -25mm (gouge)

• #11 -4mm (veiner)

• #9 -6mm (gouge)

• #9 -16mm (gouge)

• #47 -4mm (v-tool)

• 1-1.25” bench or detail knife

• #10-3mm (veiner)

• #11-2mm (veiner)

• 220 and 320 grit sandpaper